Sanyo CH0951 User Manual

Page 22

7. Remote Control Unit Installation Position

The remote control unit can be operated from either a

non-fixed position or a wall-mounted position.

To ensure that the air conditioner operates correctly, do

not install the remote control unit in the following

places:

●

In direct sunlight

●

Behind a curtain or other place where it is covered

●

More than 26 ft. (8 m) away from the air conditioner

●

In the path of the air conditioner’s airstream

●

Where it may become extremely hot or cold

●

Where it may be subject to electrical or magnetic

interference

7-1. Mounting on a Wall

1) Confirm the indoor unit beeps when the

ON/OFF button is pressed at the wall location

where the remote control unit is to be attached,

then attach the holder to the wall. (Fig. 56)

2) When taking out the remote control unit, pull it

from the holder.

When using the remote control unit

•

Point the transmission portion of the remote

control unit at the receiver area of the indoor

unit when operating the remote control unit,

and during operation of the air conditioner.

•

Do not place objects that may block the trans-

mitted signals between the receiver and the

remote control unit.

When mounting the remote control unit to

prevent theft

1) Mount the holder to the wall with one of the

screws (using only the hole in the top of the

holder) (Fig. 57).

2) Remove the cover of the remote control unit

and take out the batteries. Next, place the

remote control unit in the holder.

3) Fasten both the remote control unit and holder

to the wall with the remaining screw (using the

hole in the bottom of the holder).

4) Install the batteries in the remote control unit

and close the cover.

Truss-head
tapping screw
5/32

5/8" (4

16mm supplied)

Remote
control
unit holder

Fig. 56

Holder

Truss-head
tapping screw
5/32

5/8" (4

16mm supplied)

Fig. 57

01-385 AirCon 12/11/01 4:42 PM Page 22