Seagate BARRACUDA ATA FAMILY ST320430A - Manual (Page 31)

Barracuda ATA Family Installation Guide, Rev. A 27
Caution. If you change the drive-type values in the sys-
tem setup program, you must partition and format the
drive again.
This erases data on the drive.
• If you have partitioned the drive into individual logical drives,
you may need to make the partitions smaller to access the full
drive capacity.
• If your computer supports LBA mode, you may need to enable
LBA mode in the system setup program to access the full
capacity of the drive. Refer to your computer’s reference guide
to find out how to enable LBA.
The DOS message “Disk Boot Failure,” “Non-System Disk”
or “No ROM Basic – SYSTEM HALTED” appears.
• Reinstall the DOS system files using the DOS SYS utility.
• Check all cables.
• Use FDISK to verify that the primary partition is active.
• Check for viruses.
The system error message, “HDD controller failure”
appears.
• Confirm the jumper settings on the drive.
• Verify the drive-type settings in the system setup program.
!