Sterling 2 - Manual (Page 17)

14 Iss 1
Transportation
Transportation
Your scooter may be disassembled quickly and
simply for transportation.
1. Engage the drive unit by pushing the freewheel
lever backwards to stop the scooter from moving
during docking and transportation.
2. Lift off the front basket.
3. Remove the seat and seat stem locking pin,
leaving the seat stem in position.
4. Remove the battery pack locking screw and
battery pack. Re-insert the battery locking screw
in the battery post once the battery has been
removed. Transport battery pack in the upright
position.
5. Lower the tiller, turning it slightly past the seat
stem to its lowest setting, using the adjustment
lever provided (Photo 14.1).
6. Lock the tiller by inserting the seat stem locking
pin through the hole in the left hand handle bar
tube. This will prevent the tiller from moving
during lifting and transport (Photo 14.2).
7. De-dock the rear drive unit by lifting the docking
handle and moving the front frame forwards.
Note: The battery pack MUST be removed before
the scooter can be de-docked (Photo 14.3).
8. Using the lifting handles provided carefully lift
the scooter safely and securely into the luggage
compartment of the vehicle (Photo 14.4).
TIP:
Lift the front wheels in first and use these to roll the
frame along. Use the step at the boot opening to
rest parts if required (Photo 14.5).
To reassemble the scooter reverse the sequence
above.
Important:
When reassembling the scooter,
remember to insert the battery locking
screw, because failure to do so may
result in the batteries disengaging during
use. Always secure your scooter parts
before transportation. Do not sit on your
scooter whilst it is being transported in or
on another vehicle.
Photo 14.1
Photo 14.2
Photo 14.3
Photo 14.5
Photo 14.4