StarTech.com ENTERPRISE CLASS SV1653DXI - Manual (Page 8)

Instruction Manual
3
Installation
*SV1653DXI front panel
*SV1653DXI rear panel
To connect the KVM Remote Control Unit to the Host Computer and
Network:
Using a Category 5 Ethernet patch cable, connect the LAN connector 1.
on the rear panel of the SVxx53DXI to a network data jack (usually
on a hub, switch, router, or pre-wired wall jack).
Connect a standard PS/2 or USB keyboard to the Local Keyboard port 2.
on the rear panel of the SVxx53DXI.
Connect a standard PS/2 or USB mouse to the Local Mouse port on 3.
the rear panel of the SVxx53DXI.
Connect an XGA-compliant (or higher) monitor to the Video Out port 4.
on the front panel of SVxx53DXI.
Connect the power cord (provided) to an available electrical outlet. Plug 5.
the opposite end of the power cord into the AC power connector on the
rear of the unit.
Power up the KVM. 6.
IMPORTANT: SVxx53DXI is cooled by fans and convection. As such,
please ensure the vents on both sides as well as the rear panel are
unobstructed.