SIIG II-150 - Manual (Page 7)

7
Existing Windows Vista Installation
1.
Install the board and boot up Windows.
2. At the Found New Hardware Wizard, insert the
driver CD, select Locate and install driver software
(Recommended)
, then click Continue.
3. Click Next, select Install this driver anyway, then
click Close.
4. Remove the driver CD and restart Windows to
complete the installation.
Windows Vista (64-bit)
New Windows Vista Installation
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2. At Where do you want to install Windows?, click
Load Driver .
3. Insert driver CD, then click Browse.
4. Double click CD Drive (D:). (change D: to match
your CD-ROM drive letter).
5. Highlight Vista64 folder, then click OK.
6. Select Initio inic1620 S-ATA Adapter
(D:\Vista64\1620.inf), then click Next.
7. Follow on-screen instructions to complete Windows
Vista installation.
Existing Windows Vista Installation
1.
Install the board and boot up Windows.
2. At the Found New Hardware Wizard, insert the
driver CD, select Locate and install driver software
(Recommended)
, then click Continue.
3. Click Next, select Install this driver anyway, then
click Close.