Sirius Satellite Radio SIR-CL1 User Manual

Page 13

• The [ADJ] button is described in the source unit instruction manual either as the
[T] (TITLE) button or [A-M] button. This refers to the function of the button labeled
“ADJ” on the source unit panel.

Channel selection
Channels are selected with the following buttons.
• The

button (Seek Tuning)

• A [DIRECT] button
• The [SCN] (SC) button
• The [CAT] (RDM) button

For details, see the following operation descriptions.

Notes:

The audio output is muted and other button operations are not accepted during

the channel selection process (tuning).

Seek Tuning

1. Press the

button. The receiver seeks the next available channel

below or above the current channel.
2. Press and hold the

button for rapid or continuous channel selection.

The receiver moves to seek channels below or above the current channel. If the
channel found when either button is released is available, that channel is received.
Otherwise, seeking continues until an available channel is found.

Recalling a preset station
A total of 18 SIRIUS stations can be stored (6-SR1, 6-SR2 and 6-SR3). This allows
you to select your favorite SIRIUS stations and store them in memory for later
recall.
1. Press the [BND] button and select the desired SIRIUS band (SR1, SR2 or SR3)
to store the channel in.
2. To recall a stored SIRIUS station, press the desired [DIRECT] button to select

that station.

Storing a preset station
1. Press the [BND] button and select the desired SIRIUS band (SR1, SR2 or SR3)
to store the channel in.
2. Select the desired station with seek tuning, manual tuning or preset tuning.
3. Press and hold one of [DIRECT] buttons for 2 seconds or longer to store the

current station into preset memory.