Sharp UX-300 - Manual (Page 62)

Comments:
••••
While the handset of the fax is lifted (off hook), an extension phone
connected directly to the fax cannot be used to speak with the other party.
••••
The fax may interrupt a voice call received on an extension phone if the
reception mode is set to A.M. and there is a period of silence during the
conversation. If you are on a touch-tone phone, you can prevent this by
pressing any three keys on the phone immediately after you answer. (Note:
Do not enter the code to activate fax reception: 5,
*, *.)
Chain Dialing
After lifting the handset, you can dial any combination of Normal
Dialing, Rapid Key Dialing and Speed Dialing numbers. For example,
if you have stored an area code or an access code for a special service
in a Rapid Key, you can press the Rapid Key for that area code or
access code, then dial the remainder of the number by pressing a
Rapid Key, pressing number keys, or pressing the SPEED DIAL key
and entering a two-digit Speed Dial number.
Using the HOLD/SEARCH key
You can use the HOLD/SEARCH key to search for a Rapid Key or
Speed Dial number. First search for the number as described in Using
the HOLD/SEARCH key in Sending a Fax by Automatic Dialing in
Chapter 2, then pick up the handset or press the SPEAKER key. The
number will be dialed automatically (do not press the
START/MEMORY key).
Redial
The last number called can be redialed by pressing the REDIAL key
(it is not necessary to pick up the handset or press the SPEAKER
key). When the other party answers, pick up the handset to talk.
Making Telephone Calls
60