Soleus Air KC-45H - Manual (Page 12)

10
6. INSTALL THE CASE IN THE WINDOW
(cont.)
D. Adjust the leveling bolts and nuts against the
outside wall so that the case has a slight tilt to
the outside. Tighten nuts with an adjustable
wrench. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
E. Use a wood block (not supplied) between the
leveling bolts and the wall if the wall is weak
or if the weight of the air conditioner falls
between the studs in the wall.
F. Extend the left and right accordion panels to
the vertical window sashes. Drill pilot holes
and attach the top and bottom corners with 4
type D screws.
7. INSTALL SUPPORT BRACKETS AND THE
FOAM TOP WINDOW GAS KET
A. Attach the support brackets with two type D
screws, one on each side.
B. Cut the foam top window gasket to the
window width.
C. Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
Installation Instructions (Continuous)