beautypg.com

Installation of the appliance, 1 electrical connection, Instructions for the installer – Smeg A11A-6 User Manual

Page 4

background image

Instructions for the installer

6

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by

authorised persons.

Clearance around the cooker must comply with the requirements of

AS5601.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications
indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.


On the power line, install an omnipolar cut-off device with contact cut-off
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.

If the power cable is replaced, the wire

section on the new cable must not be

less than 1.5 mm

2

(3 x 1.5 cable),

keeping in mind that the end to be

connected to the hob must have the

ground wire (yellow-green) longer by at

least 20 mm. Use only the special

cables available at our Service

Centres.

The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.

Overall dimensions: location of gas and electrical connection points (all
measures in mm).

A

110

B

760

C

150

D

170