Ta p e recor d in g, Recording from the radio, Dubbing from tape to tape – Sharp CD-DP900E User Manual
Page 23: Erasing recorded tapes
23
CD-DP900E(UK)_2.fm
02/1/8
CD-DP900E
T
a
p
e
Recor
d
in
g
- Rec
o
rd
in
g
t
o
a ca
sse
tt
e
ta
p
e
-
Recording from the radio
To interrupt recording:
Press the REC PAUSE (
) button.
To resume recording, press the / (TAPE 2 ) button.
To stop recording:
Press
the
(TAPE )
button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press
the
(TAPE )
button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1
Tune in to the desired station. (See page 19.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE (
) button.
Recording will be paused.
4
Press the / (TAPE 2 ) button to
start recording.
Erase-prevention tab of cassette tapes:
When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
Side A
Tab for side B
Tab for side A
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the
TAPE 1 cassette compartment. Insert
a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is
the same length as the master tape.
3
Press the TAPE (1 2) button until
"TAPE 1" appears on the display.
4
Press the REC PAUSE (
) button.
Recording will be paused.
5
Press the / (TAPE 2 ) button to
start dubbing.
1
Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2
Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3
Press the REC PAUSE (
) button.
4
Press the / (TAPE 2 ) button to start erasing.
Tuning (See page 19.)