Sharp CD-DP900E - Manual (Page 16)

16
CD-DP900E(UK)_2.fm 02/1/8
CD-DP900E
CD Pla
y
ba
c
k
- L
ist
en
in
g
t
o
a CD
(
C
Ds)
-
Listening to a CD (CDs)
This system can also play audio CD-R and CD-RW discs, but cannot record.
Some audio CD-R and CD-RW discs may not be playable due to the state of disc or
the device that was used for recording.
To interrupt playback:
Press the CD button on the remote control.
To resume playback from the same point, press the button.
To stop playback:
Press the (CD ) button.
To remove the CDs:
Whilst in the stop mode, press the OPEN/CLOSE button.
The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to
rotate the disc tray and remove the remaining disc.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
4
Place the CD(s) on the disc tray, label side up.
When loading a third disc, press the DISC SKIP button to turn the
disc tray, then place the CD in the open position.
CDs can be placed on any open position on the disc tray.
Be sure to place 8 cm (3") CD(s) in the middle of the disc positions.
12 cm (5") 8 cm (3")
5
Press the OPEN/CLOSE button to close the disc tray.
Total number of tracks on the CD
whose number is flashing Total playing time of the CD whose
number is flashing
6
To select the CD you want to listen to first, press the DISC SKIP
button.
7
Press the / ( ) button to start playback.
Playback will begin from track 1 on the disc you have selected to play. After
that disc finishes playing, the next disc will automatically start playback.
When the last track on the third disc has finished playing, the CD player will
stop automatically.
When there is no CD in one of the disc 1 - 3 positions, that position will be
skipped and the next CD will be played.
Sound control (See page 14.)