Star Micronics SP500 Series - Manual (Page 17)

– 14 –
ENGLISH
H
V
OFF
ON
ERROR
POWER
FEED
H V
O FF OFF
O N ON
ER RO R
ERROR
PO WE R
POWER
FE ED FEED
H
V
OFF
ON
ERROR
POWER
FEED
4 While observing the direction of the
roll, set the paper roll into the hol-
low as shown in Fig. 5-5.
5 Insert the edge of the paper into the
paper feeder (black plastic part). If
inserted correctly, the edge of the
paper will pass through the paper exit.
6 Insert the top edge of the paper into
the tear bar slot, then mount the cover
by reversing the procedure for open-
ing the cover in step 1 above.
Note: When the paper end mark ap-
pears on the paper, replace the
roll paper before it runs out.
Fig. 5-5 Setting the paper
Fig. 5-6 Loading the paper
Fig. 5-7
Roll paper
Roll paper
Tear bar
Paper feeder
Paper exit