Sanyo PLC-EF60 - Manual (Page 31)

31
Basic Operation
Information
Choose either Input 1, Input 2, Input 3, Input 4, or Input 5 by
pressing the INPUT button on the top control or the INPUT 1,
INPUT 2, INPUT 3, INPUT 4, or INPUT 5 button on the remote
control.
Before using these buttons, correct input source should be
selected through menu operation as described on p37~38.
Input 1
Input 3
Input 2
INPUT button
Input 5
Input 4
Auto PC Adjustment function is provided to automatically adjust
Fine sync, Total dots, Horizontal, and Vertical picture position to
conform to your computer by just pressing the AUTO PC ADJ. on
the top control or the AUTO PC button on the remote control.
Information display can be used to confirm the current operating
condition of the projector and the signal being projected through
the projector.
Press the INFO button to display Information window on screen.
To hide the Information window, press the INFO button again.
Use this menu to check the projector's operating condition when
you face troubles in operation. Refer to the Information menu on
page 61.
✔
Note:
• Fine sync, Total dots and Picture Position of some computers can not be fully
adjusted with this Auto PC Adjustment function. When the image is not provided
properly with this operation, manual adjustments are required. (p42, 43)
• Auto PC Adjustment function cannot be operated in Digital Signal input on DVI
terminal and “480i”, “575i”, “480p”, “575p”, “720p (HDTV)”, “1035i (HDTV)”,
“1080i/50 (HDTV)” or “1080i/60 (HDTV)” is selected on System menu (P40).
Auto PC Adjustment
Input Selection
Basic Oper
ation