Samsung DCS 400si - Manual (Page 28)

INVALID CID INFO This is a message that will be displayed when CID infor-
mation is sent on the line but was somehow corrupted.
NO CID RECEIVED This is a message that will be displayed when there was
no CID information sent on the line.
NO CID DSP Caller ID Digital Signal Processors (CIDDSP’s) are
resources in the DCS 400si required for receiving CID
data. If there are no CIDDSP’s available at the time a
call comes in, this is the message you will see on your
display.
NOTE: The Caller ID features require optional software and/or hardware.
Please see your service and installation company for details.
WHAT IS ANI?
ANI (Automatic Number Identification) is a feature offered by some tele-
phone service providers that provides the calling party’s telephone number.
This service is only available on E&M Tie Lines on a T1, digital trunk. ANI is
similar to Caller Identification (CID) but the format and information of the
calling person is different. CID uses FSK signalling and ANI uses DTMF sig-
nalling. Usually, with ANI, a calling party’s identity is the Listed Directory
Number (LDN) unless a separate bill-to-number has been specified, (in
which case the bill-to-number will be sent). Along with the ANI digits you
also receive DNIS digits with a separator digit. The DNIS digits are used to
tell the phone system where to route the call. Note that ANI does not pro-
vide calling party NAME, only the number. The phone system can provide
calling number to name translation table.
SELECTING YOUR CALLER ID/ANI
DISPLAY
You can decide if you want to see the CID/ANI name or CID/ANI number in
the display. Regardless of which one is selected, you can press the NND
key to view the other pieces of CID/ANI information. To select the type of
Caller ID information you wish to view first:
• With the handset on-hook, press TRANSFER and then dial 119.
• Dial 0 for CID options or 1 for ANI options.
• Dial 0 if you do not wish to view CID/ANI information, 1 to view the NUM-
BER first or 2 to view the NAME first.
• Press TRANSFER to exit and store your selection.
49
PSMG . . . . . . .Programmed Message 01–30
RP . . . . . . . . . .Ring Plan . . . . . . . . . . .(1–6), HOLD for none
SG . . . . . . . . . .Station Group . . . . . . .500 or 5000 through 549 or 5049
SPD . . . . . . . .Speed Dialing . . . . . . .00–49, 500–999
DIR . . . . . . . . .Directory . . . . . . . . . . .PERS (1), SYS (2) or STN (3)
VT . . . . . . . . . .Voice Mail Transfer . . .Voice Mail Group (501–549)
NOTE: Confirm that the cursor is placed correctly before you enter the ex-
tender.
WHAT IS CALLER ID?
Caller ID is the name given to the telephone company-provided feature that
delivers the telephone number and sometimes the name of the person call-
ing your phone. There are two types of Caller ID; the first delivers the calling
party’s telephone number only and the second (sometimes referred to as
“Deluxe” Caller ID) delivers both the calling party’s telephone number and
name as listed in the telephone directory.
The phone system can handle both types of Caller ID; in fact, in the case of
number only delivery, the system can be programmed to insert a name for
a specific telephone number (up to a maximum of 1500 numbers). However,
even though you are paying to receive Caller ID information, there are some
circumstances that mean you will not receive this information. The six most
common reasons are listed below along with the display information that the
system will provide.
PRIVATE The caller does not wish his/her name or number to be
revealed to you. This type of call can be stopped at the
telephone company by dialing an access code on your
outside lines. This will redirect these PRIVATE calls to
an announcement that states that you do not wish to re-
ceive calls that have had Caller ID blocked. The code to
block these calls can usually be found in the front sec-
tion of the telephone directory.
OUT OF AREA The caller is calling from an area that cannot provide
Caller ID information (for example, international calls) or
he/she is calling from a type of circuit that cannot pro-
vide Caller ID information, for example, some outbound
WATS lines.
PAYPHONE The caller is calling from a coin-operated telephone.
The telephone company will send this information as
there are no directory listings for pay phones. The num-
ber will be delivered as usual.
48