Fine-tuning the signal, Other information – Samsung SL10D10 User Manual

Page 70

Follow these steps to run the diagnostics system test on your Samsung Fliptop powered by
DIRECTV

1) Turn on your Samsung Fliptop powered by DIRECTV

2) Set the

Video Source to DIRECTV in the LCD panel menu. (See page 13 for more details)

3) Slide the mode switch to the DIRECTV position to put the remote control in satellite receiver-

controlling mode, then press MENU to bring up the Quick Menu.

4) Select

Settings.

5) Select

Setup, then Info & Test.

6) Use arrow keys to highlight the

System Test tab, then press SELECT on Run Test.

7) If your system does not pass the system test, check any of these potential trouble areas: cabling,

pointing the satellite dish, phone connection and access card.

You should run a system test several times before concluding that there is a problem. Occasional
ﬂuctuations in the phone line or satellite signal can give temporary false readings.

Fine-Tuning the Signal

If you self-installed your satellite dish antenna, you may have already used

Guided Setup to ﬁnd the

dish-pointing coordinates, acquire and ﬁne-tune the signal and run a system test. If you need to
run

Guided Setup again, select Settings from the Quick Menu, then select Guided Setup. Next, press

SELECT on

Satellite, then select Repeat Satellite Setup.

Other Information

Troubleshooting

This manual is related to the following products:

SL10D10-XAA