Sirius Satellite Radio Orbiter SR4000 User Manual

Page 6

Orbiter SR4000 User Guide

Searching Channels (Channel List Mode)

It is possible to search for a different channel while
listening to your current channel. Be sure that the
display shows the Default screen prior to the
following steps:
1. Press and hold the DISP button for 2-seconds to

activate the Channel List Mode (top right). The
Channel List screen will appear, showing all available
channels regardless of category:

• Pressing the DISP button while in the Channel

List Mode will change between Channel Name,
Artist Name (middle right), and Song Title (bottom
right). You can use this feature to search for a
specific Artist or Song that may be playing at the
time.

2. Turn the Rotary Knob up or down to find the channel

you want.

Press and Hold the
DISP button to enter
the Channel List
Mode

Press DISP again to
show the Artist Name

Press DISP again to
show the Song Title

Press DISP again to go
back to Channel List

Search Modes (Category, Channel, Artist,

Song Title)

The SR4000 Receiver has four ways to search for and
select music: by category, by channel, by artist, and by
song title.

Searching Categories

If you want to listen to a different entertainment
category, push the CATEGORY button up or down to
activate the Category Select screen (top right):
1. Use the CATEGORY button to scroll through music

and entertainment categories.

2. When the category (ex. Rock) you want is highlighted,

use the Rotary Knob to search available channels
within the category.

• Pressing the DISP button while in the Category

Search mode will change between Channel Name,
Artist Name, and Song Title to be able to preview
what is playing on other channels before selecting.

3. When the channel you want is highlighted, press the

Rotary Knob. The channel will change and the display
will revert to the Default screen for the new channel.

To exit this mode without changing to a new channel,
press and hold the DISP button for 1-second.

Direct Tuning

Channels can also be directly accessed by pressing
and releasing the Rotary Knob and using the 0-9
number keys to numerically enter the desired channel
(below). Once the desired channel number has been
entered, the channel will change and the display will
revert to the Default screen for the new channel.
Note: The receiver will change immediately if three
numbers are entered (ex. “0”, ”0”, “7”), but if just one
or two digits are entered, the unit will change to that
channel 3-seconds after the last number was
entered.

3. Press and release the Rotary Knob to select the

channel. To exit this mode without changing to a new
channel, press and hold the DISP button for 1-second.