Simpson 52C850 - Manual (Page 19)

Ensure that the hoses
are not kinked, crushed
or entangled.
WARNING!
●
Safety standards require the appliance to be
earthed.
●
Prior to using the appliance for the first time,
ensure that the rated voltage and type of
supply on the rating plate match that of the
supply where the appliance is to be installed.
The fuse rating is also to be found on the
rating plate.
●
Always plug the mains plug into a correctly
installed approved socket.
●
Multi-way plugs, connectors and extension
cables must not be used. This could
constitute a fire hazard through overheating.
●
If necessary, have the domestic wiring
system socket replaced. If the electrical
supply cord has to be replaced, contact your
local Customer Care centre.
●
The plug must be accessible after the
appliance has been installed.
●
Never unplug the appliance by pulling on the
cable. Always pull the plug.
The manufacturer accepts no liability for failure
to observe the above safety precautions.
Electrical connection
Remove internal membrane from drain spigot.
When connecting the drain hose to an under sink
trap spigot, the entire plastic membrane must be
removed. Failure to remove all the membrane will
result in food particles building up over time
eventually blocking the dishwasher drain hose
spigot.
WARNING!
Ensure that the dishwasher has been tested
using the rinse & hold or quick 30 cycle and
that the dishwasher fills with water, washes
and drains with no leaks.
156998841.qxp 12/13/2006 3:34 PM Page 19