Simpson 52C850 - Manual (Page 15)

15
The wash results are not satisfactory
The dishes are not clean
● The wrong washing program has been selected.
● The dishes were arranged in such a way as to stop water reaching all parts
of the surface. The baskets must not be overloaded.
●
The spray arms do not rotate freely due to wrong arrangement of the load.
● The filters in the base of the washing compartment are dirty or incorrectly
positioned.
●
Too little or no detergent has been used.
● The drain hose connection is not correct.
The dishes are wet and
dull
● Rinse aid was not used.
● The rinse aid dispenser is empty.
Water drops have dried
onto glasses and dishes
● Increase rinse aid dosing.
● The detergent may be the cause, Contact the detergent manufacturer’s
consumer care line.
There are streaks, milky
spots or a bluish coating
on glasses and dishes
● Decrease rinse aid dosing.
If after all these checks, the problem persists,
contact your local Customer Care Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door (see picture).
So that you always
have these numbers
at hand, we
recommend you note
them here:
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . .
156998841.qxp 12/13/2006 3:34 PM Page 15