Sharp R-820BC - Manual (Page 13)

10
SEC R-820JS/BC O/M
TINSEB053WRRZ-D41 SEC R-820JS/BC O/M
CONVEC
CONVECTION COOKING
M A N U A L O P E R A T I O N
During convection heating, hot air is circulated through-
out the oven cavity to brown and crisp foods quickly
and evenly. This oven can be programmed for ten dif-
ferent convection cooking temperatures for up to 99
minutes, 99 seconds.
The oven should not be used without the turntable in
place, and it should never be restricted so that it can-
not rotate. You may remove the turntable when pre-
heating the oven and when preparing food to be cooked
directly on the turntable.
Warning:
All of the oven parts, including the bottom heater as
well as the rack and cooking containers, may become
very hot. Use caution when removing any item from
the oven. Use heavy potholders or oven mitts to PRE-
VENT BURNS.
CONVECTION SETTINGS
S E T T I N G
CONVECTION SETTINGS
1. Convection with preheat
2. Convection without preheat
SPECIAL CONVECTION SETTINGS
3. Cakes
4. Angel food cake
5. Yeast bread
1. To Preheat and cook with Convection
Your oven can be programmed to combine preheating
and convection cooking operations. You can preheat
to the same temperature as the convection tempera-
ture.
• Suppose you want to preheat to 350° F. and then
cook 25 minutes at the same temperature.
P R O C E D U R E D I S P L A Y
1
2
Touch Convec pad.
Touch number pad for
selected Convec
setting.
3
Select preheat
temperature.
Enter cooking time.
4
NUMBER
SEE
CONVEC
LABEL
3 5 0 F
1
SELECT
TEMP
6
25.00
350F
6
START
TOUCH ON
Touch Start/ Touch On pad.
When the oven reaches the programmed
temperature, a signal will sound 4 times.* The oven
will stop, and directions will be displayed. Follow the
indicated message.
Touch Start/
Touch On pad.
5
START
TOUCH ON
* If the oven door is not opened, the oven will auto-
matically hold at the preheat temperature for 30 min-
utes. After this time has elapsed, an audible signal
will sound, and the oven will turn off.
NOTE:
1. To program only preheat, touch the Start/Touch on
pad after step 3. Preheating will start. When the oven
reaches the programmed temperature, follow the
indicated message.
2. If you are in the process of preheating and wish to
check the actual oven temperature, simply touch the
Convec pad. The actual oven temperature will be
displayed as long as the Convec pad is touched. If
the oven temperature is below 100°F at this time,
LO F will be displayed.
2. Cook with Convection without Preheat
To cook without preheat, touch 2 in step 2. Select the
cooking temperature, time and press Start/Touch On
pad, following the indicated message. Oven starts to
cook immediately.
SELECT
PREHEAT
350F
COOK
2 5 0 0
R-820JS/BC 01-10 04.4.16, 9:30 AM 10