Star Trac SPINNER BIKE NXT 7000 - Manual (Page 4)

Page 3 of 9Star Trac Product Support 800-503-1221
Page 3 of 9
NXT Only
1. Position the leg so the thicker end faces toward
the front of the bike
2. Using the 5mm hex wrench and a 13mm
combination wrench insert 2- M10X55mm (rear-
most holes) and 2-M10X65mm (front-most holes)
button head screws, nuts and washers (under bolt
head and nut), to secure the rear leg assembly to
the frame. The nut should be on the bottom of the
bike and the head of the screw on the top of the
bike.
3. Tighten all hardware securely using a torque
wrench to 85 Inch Pounds
Pro & Elite Only
1) Using the 5mm hex wrench and a 13mm
combination wrench insert 2- M10X55mm flat
head screws, nuts and washers to secure the rear
leg assembly to the frame. The nut should be on
the bottom of the bike and the head of the screw
on the top of the bike.
2) Tighten all screws/nuts securely using a torque
wrench to 85 Inch Pounds
Position the bike on a flat surface and adjust the
leveling feet so the bike is stable.