Shindaiwa 68006-94310 - Manual (Page 16)

16
Inspection and Maintenance
Item What to Do Daily Weekly Monthly As Req’d
Air Cleaner Clean

Cut-off Wheel Check & Sharpen 
Bolts/Screws Check & Retighten 
Fuel Cap Check Leakage 
Fuel Tank Check Leakage 
Wheel Guard Check Function 
Clutch Bearing Grease 
Belt Check and Adjust 
Spark Plug Check and Clean 
Cylinder Fins Clean 
Fuel Filter Clean 
Carburetor Adjust 
Inspection and Maintenance Requirements
Figure 19
5. Making sure that the drive belt is
fully engaged in the drive pulleys,
slide the belt cover on and install
the two socket-head bolts into the
left-hand side of the mounting sur-
face only until the bolts bottom on
the belt cover. See Figure 19.
6mm Socket-
Head Bolts Figure 20
6. Adjust the tension screw until the
tension indicator is in the middle of
the scale. See Figure 20.
7. Tighten the two mounting bolts
securely.
8. Reconnect the main water line,
adjust and retighten water nozzles
(if equipped with a water kit).
9. Reinstall the cutting wheel.
Reversing cutting head for flush cutting opera tions
(cont.)
MAINTENANCE, REPLACEMENT, OR REPAIR OF EMISSION CONTROL DE-
VICES AND SYSTEM MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT
OR INDIVIDUAL. HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY
A DEALER OR SERVICE CENTER AUTHORIZED BY SHIN-DAIWA KOGYO, LTD.
AND USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND
DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS
OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE
OUTCOME OF THE WARRANTY CLAIM.