Samsung PS-63 A756T1M User Manual

Page 18

English - 1

Real 100Hz Demo→ Off / On

You can get a clear distinction between

Real 100Hz and 50Hz, especially when watching fast moving scenes. Therefore, when

seeing slow moving scenes, you will not be able to distinguish between

Real 100Hz and 50Hz. Demo 100Hz works only with

50Hz signal. Real 100Hz demo mode is provided for shop demonstration with special pictures.

Movie Plus → Off / Low / Medium / High / Demo

You can view more natural skin and clear text even in fast moving scenes.

Use this function when watching movies.

This function is not available in

Wide Zoom and Zoom modes.

This function is not available when

PIP is set to On.

It is not supported in HDMI 1080p/24Hz, 25Hz, 30Hz mode.

Blue Only Mode → Off / On

This function is for AV device measurement experts. This function displays the blue signal only by removing the red and

green signals from the video signal so as to provide a Blue Filter effect that is used to adjust the Colour and Tint of video

equipment such as DVD players, Home Theaters, etc. Using this function, you can adjust the Colour and Tint to preferred

values appropriate to the signal level of each video device using the Red / Green / Blue / Cyan / Magenta / Yellow Colour Bar

Patterns, without using an additional Blue Filter.

Blue Only Mode is available when the picture mode is set to Movie or Standard.

Screen Burn Protection

To reduce the possibility of screen burn, this unit is equipped with screen burn prevention technology. This technology enables

you to set picture movement up/down (Vertical Line) and side to side (Horizontal Dot). The Time setting allows you to program

the time between movement of the picture in minutes.

Pixel Shift: Using this function, you can minutely move pixels on the PDP in horizontal or vertical direction to minimize after

image on the screen.

Set

Pixel Shift to On by pressing the ▲ or ▼ button, then press the ENTER button.

Select the required option by pressing the ▲ or ▼ button, then press the

ENTER button.

Available options:

Horizontal Dot, Vertical Line, Time.

Optimum condition for pixel shift;

TV/Ext/AV/Component/HDMI

Horizontal Dot

Vertical Line

Time (minute)

2 min

The Pixel Shift value may differ depending on the monitor size (inches) and mode.

This function is not available in the

Just Scan mode.

All White: This function helps remove after images on the screen by changing the colour of pixels to white. Use this

function when there are remaining after images or symbols on the screen especially when you displayed a still image on the

screen for a long time.
Scrolling: This function helps remove after images on the screen by moving all the pixels on the PDP according to a

pattern Use this function when there are remaining after images or symbols on the screen especially when you displayed a

still image on the screen for a long time.
Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the

white balance on both extreme left and right sides.

Dark: When you set the screen ratio to 4:3, it darkens the left and right sides.

Light: When you set the screen ratio to 4:3, it brightens the left and right sides.

Picture Reset → Reset Picture Mode / Cancel

Resets all picture settings to the default values.

Select a picture mode to be reset. The reset is performed for each picture mode.



N
N
N
N



•

N
N
N
N

N
N

•

❑

BN68-01757D-Eng_.indb 18

2008-08-20 오후 7:18:24