Sunrise Medical Sterling - Manual (Page 12)

101266 Rev. B 12
E N G L I S H
A. BATTERY CASE REMOVAL
To remove the batteries for transporting or servicing:
1. Remove Battery Case
a. To remove battery pack, lift up on battery pack handle (A).
2. Battery Installation
See Section X. Batteries, D for installation.
Batteries may weigh up to 25 lbs. Care must be taken to avoid injury when
lifting up on battery handle.
B. ARMRESTS ADJUSTMENT
1. Width Adjustment
a. Insert armrest support inside of 1" square tube located on back of the seat.
b. Repeat for other side of seat.
c. Position armrest at appropriate width.
d. Tighten knob screws (B) on square tube.
Avoid pinching fingers in the flip-back armrest.
C. SEAT REMOVAL
1. Unplug the controller connections at the back of the seat.
2. Lift the chair straight up off of the seat mount.
3. When replacing the seat onto the mount, make sure the seat is aligned properly and does not
swivel before sitting.
Keep hands away from the seat post when replacing the seat to ensure
you do not pinch your fingers.
2
1
A
1
B
2