Smooth Fitness CE-3.0 - Manual (Page 11)

www.smoothfitness.com 11
ASSEMBLY
STEP 3: Attach the Left and Right Pedal Arms, Connecting Tubes and Covers
(A) Rotate the crank arm of the elliptical so the pedal arm (88) can be attached to the crank arm. (see diagram 4a
and 4b)
(B) Secure the right pedal arm to the crank arm with 1 x OD20*ID10.5*2.0T flat washer (44) and M10*1.5*6.35T
Nut (89) Tighten all bolts now.
(C) Attach the connecting tube (56) to the right action handlebar (28) (see diagram 4c).Secure the arm with 2 x
M8*20 bolt (9), 2 x M8*2.0T spring washer (15) and 2 x OD20*ID8.5*1.5T flat washer (14) (see diagram 4c)
(D) Put the left and right connecting tube covers (58 & 57) over the connecting tube / action handlebar joint ( see
diagram 4d) Secure the covers together with 5 x M4*20 screws (13)
(E) Position the pedal arm roller on to the aluminum roller track (see diagram 4e). remove the M8*20 bolt (9),
OD20*ID8.5*1.5T flat washer (14) and M5*10 screw (101), Install the retaining loop from under the roller track
support tube (77) and line up the holes on the retaining loop and the roller bolt holes (previously removed). Then
reinsert the M8*20 bolt (9), OD20*ID8.5*1.5T flat washer (14) and M5*10 screw (101), to secure both the retaining
loop and the roller. Fully tighten all bolts now.
(F) Repeat the above processes for the left side.
4a
4e
4b
4a
4d
4c
101
102
89
44
9
15
14
88
9 15 14
102
102
89
44
99
56
106
60
28
77
58
13
57
13
57
58
105
105
54
54
Crank arm
bracket
89
44
88
9
15
14
103
77
101
105
9
14
13
57
58