Sharp Notevision XG-C435X-L - Manual (Page 33)

-31
Basic Operation
Image Projection
Height Adjustment button
Side View
Lens
center
Top View
Using the Adjustment
Feet
The height of the projector can be adjusted
using the adjustment feet when the screen is
located higher than the projector, the screen
is inclined or when the installation site is
slightly inclined.
Install the projector so that it is as perpen-
dicular to the screen as possible.
1
Press the Height Adjustment but-
tons.
•
The adjustment feet come out.
2
Lift the projector to adjust its
height and remove your hands
from the Height Adjustment but-
tons.
•
The projector is adjustable up to approxi-
mately 9 degrees.
3
Rotate the Tilt dial to finely ad-
just the horizontal tilt of the pro-
jector.
•
The inclination is adjustable within ap-
proximately 2 degrees.
•
When adjusting the height of the pro-
jector, trapezoidal distortion occurs.
When “Auto V-Keystone” of the “SCR-
ADJ” menu is set to “On” (see page
49 ),
keystone correction functions automati-
cally to correct trapezoidal distortion.
When you want to adjust the automati-
cally corrected image, use the manual
keystone correction. (See page
32 .)
Info
•
Do not press the Height Adjustment button
when the adjustment feet come out without
firmly holding the projector.
•
Do not hold the lens when lifting or lower-
ing the projector.
•
When lowering the projector, be careful not
to get your fingers caught in the area be-
tween the adjustment foot and the projector.
Adjustment foot
Tilt dial