beautypg.com

Assembly, Install blower pipes, Filling the fuel tank starting the engine – Shindaiwa X7501920500 User Manual

Page 9

background image

9

Storage - Fuel storage laws vary by

locality. Contact your local govern-

ment for the laws affecting your area.

As a precaution, store fuel in an ap-

proved, airtight container. Store in a

well-ventilated, unoccupied building,

away from sparks and flames.

IMPORTANT!

Stored fuel may separate. ALWAYS

shake fuel container thoroughly be-

fore each use.

Mixing Instructions

1. Fill an approved fuel container with half of the required amount of

gasoline.

2. Add the proper amount of engine oil to gasoline.

3. Close container and shake to mix oil with gasoline.

4. Add remaining gasoline, close fuel container, and remix.

IMPORTANT!

Spilled fuel is a leading cause of hydrocarbon emissions. Some states may

require the use of automatic fuel shut-off containers to reduce fuel spillage.

After use

• DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused

fuel to an approved fuel storage container.

Remove

the

Fuel

Filler

Cap

Figure 4

1. Place the blower on a flat, level surface.
2. Clear any dirt or other debris from around the fuel filler cap.
3. Remove the fuel cap, and fill the tank with clean, fresh fuel.
4. Reinstall the fuel filler cap and tighten firmly.
5. Wipe away any spilled fuel before starting the blower.

Filling the Fuel Tank

Starting the Engine

Starting Procedure
1. Place the blower on the ground.
2. Prime the fuel system by repeat-

edly

depressing the fuel primer bulb

until no air bubbles are visible in

the fuel discharge line.

The impeller will rotate whenever the blower is operated! Never operate

this blower unless the intake cover and blower tubes are properly installed

and in good working order!

CAUTION!
The recoil starter can be damaged by abuse!

• Never pull the starter cord to its full length!
• Always engage the starter before cranking the engine!
• Always rewind the starter cord slowly!
Never operate the blower if blower tubes are missing or damaged!

Danger from rotating impeller!

WARNING!

WARNING!

Danger from thrown dust or debris!

Always wear eye protection when operating this machine! Never direct the

blower stream toward people or animals!

Never operate this blower unless all controls are properly installed and in

good working order.

3.

Cold Engine Only. Choke the

engine by moving the choke lever

up (choke is closed). See Figure 5.

Choke

Open

Choke

Closed

Figure 5

IMPORTANT!

The primer system only pushes fuel

through the carburetor. Repeatedly

pressing the primer bulb will not flood

the engine with fuel.