Sony Multi-Profile CCD Box Type Network Camera HQ1 - Manual (Page 43)

Network Camera User’s Guide
43/83
2. Make sure that only you access this device while firmware updating.
3. Disable Motion Detection function.
4. Click “Browse” button. Select the Firmware binary file. ( Note that it must make sure
that the Firmware only applies to this device, once update, it will be burned into FLASH
ROM of system.
)
5. Once the firmware file was selected, click “Firmware Upgrade” button.
6. The upgrade progress information will be displayed. Once the uploading process
completed, the device will reboot the system automatically.
7. Please wait for timer countdown, and then you can use IPWizard to search the device
again.
Warning!!!
The download firmware procedure can not be interrupted. If the
power and/or network connection are broken during the download procedure, it
might possibly cause serious damage to the device.
Strongly suggest that DO NOT upgrade firmware via Wireless LAN due to high
error rate possibly and don't allow any other clients to access this unit during
updating procedure.
Be aware that you should not turn off the power during updating the firmware and
wait for finish message.
Furthermore, the firmware upgrade procedure always is risk and do not try to
upgrade new firmware if it’s not necessary.
System Restart:
The device is restarted without changing any of the network settings. It means the IP
address of the device will not change after firmware upgrade.