Samsung WF7758S6 - Manual (Page 8)

A-3 SAMSUNG Washing Machine Owner’s Instructions
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the water
faucet at the other. Do not stretch the water supply hose. If the hose is too short replace the hose
with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold water
supply hose and connect to the cold water
supply intake on the back of the machine.
Tighten by hand.
2. Connect the other end of the cold water
supply hose to your sink’s cold water faucet
and tighten it by hand. If necessary, you can
reposition the water supply hose at the washing
machine end by loosening the fitting,rotating
the hose, and retightening the fitting.
Option:
1. Take the red L-shaped arm fitting for the hot water supply hose and connect to the red hot
water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink’s hot water faucet and
tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
Note: The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be used.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin.
The drain hose must be placed at a height of
between 60 and 90 cm. To keep the drain hose spout
bent, use the supplied plastic hose guide. Secure
the guide to the wall with a hook or to the faucet
with a piece of string to prevent the drain hose from
moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm
above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm
and no longer than 90 cm.
Installing the Washing Machine
WF7750S6-02376K-01_EN.indd 3 2007-08-24 ¿ААь 11:06:36