Installing the washing machine, Selecting a location, Adjusting the leveling feet – Samsung WF7758S6 User Manual
Page 7: Removing the shipping bolts, Connecting the water supply hose (option)
SAMSUNG Washing Machine Owner’s Instructions A-2
Selecting a location
Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see “Adjusting the leveling feet,” below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0 ˚C
• Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed
on a carpeted floor.
Adjusting the leveling feet
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the
feet):
1. Loosen the leg bolt by turning it with your hand
until it is at the desired height.
2. Tighten the locking nut by turning it with the
supplied wrench.
If the washer is placed on an uneven or weak
surface, noise or vibration occurs. (Only l degree
angle is allowed.)
Removing the shipping bolts
Before using the washing machine, you must remove the five shipping bolts from the back of the
unit. To remove the bolts:
1. Loosen all bolts with the supplied wrench before
removing them.
2. Take each bolt head and pull it through the wide
part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.
Connecting the water supply hose (Option)
1. Remove the adaptor from the
water supply hose.
c
4. Connect the water supply hose
to the adaptor. Pull down part (c)
of the water supply hose.When
you release part (c) the hose
automatically connects to the
adaptor making a ‘click’ sound.
2. First, using a ‘+’ type screw driver,
loosen the four screws on the
adaptor. Next, take the adaptor
and turn part(b) following the
arrow until there is a 5mm gap.
5. Connect the other end of the
water supply hose to the inlet
water valve at the rear of the
washer. Screw the hose clockwise
all the way in.
3. Connect adaptor to the water tap
by tightening the screws firmly.
Then, turn part (b) following
the arrow and put(a) and (b)
together.
a
b
• If the water tap has a screw type
faucet, connect the water supply
hose to the tap as shown.
NOTICE:
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square
or too big, remove the spacing ring before inserting the faucet into the adaptor.
Installing the Washing Machine
��
���
���
�������������
����
����
�����������
��������
���������
�����
����
�����
��������������
�����������
�����
����
��������
���
������
����
��������
���������
������
�����
�����
�����
1
2
3
WF7750S6-02376K-01_EN.indd 2
2007-08-24 ¿ААь 11:06:35