Sennheiser SK 500 G3 - Manual (Page 25)

24
Adjusting settings via the operating menu
The extended menu “ Advanced Menu ”
Setting transmission frequencies and frequency banks –
“Tune”
Via the “ Tune ” menu item, you can set a transmission
frequency to be stored in the current channel or you can
select a different channel in one of the frequency banks
“
U1 ” to “ U6 ” and assign this channel a transmission
frequency.
Setting a transmission frequency for the current channel
̈
Set the desired frequency.
Selecting a frequency bank and a channel and assigning
this channel a frequency
When you have selected one of the system banks
and then select the “
Tune ” menu, the bodypack
transmitter automatically switches to channel 1 of
the frequency bank “
U1 ”. In this case, “ U1.1 ” briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks
“
U1 ” to “ U6 ” are not assigned a transmission
frequency.
When you are in the “ Tune ” menu item, the RF
signal is deactivated.
It is vital to observe the notes on frequency
selection on page 28.
̈
Press the rocker button until the “ Tune ” menu
item appears.
̈
Press the SET button.
The frequency selection appears.
̈
Press the SET button.
Your settings are stored.
You are back to the operating menu.
̈
Press the rocker button until the “ Tune ” menu
item appears.
̈
Keep the SET button pressed until the frequency
bank selection appears.
Select the MHz
value and confirm Select the kHz
value; store the
setting
542 .625 MHz
Tune
544. 625 MHz
B.Ch: U1. 1 B.Ch: U1. 1
Tune
Call up “Tune”
Advanced Menu
Tune
“Stored”
542.625 MHz
SET SET
SET