Sennheiser SK 500 G3 - Manual (Page 13)

12
Using the bodypack transmitter
Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of
the receiver).
2. Switch the bodypack transmitter on (see next section).
The transmission link is established and the display
backlighting of the receiver changes from red to orange.
If you cannot establish a transmission link between body-
pack transmitter and receiver, refer to the chapter
“Synchronizing the bodypack transmitter with the receiver
– individual operation” on page 28.
Switching the bodypack transmitter on/off
̈
Push the two battery compartment catches
¸
and open
the battery compartment cover
µ
.
To switch the bodypack transmitter on (online operation):
It is vital to observe the notes on frequency
selection on page 28.
̈
Briefly press the ON / OFF button
Ƹ
.
The bodypack transmitter transmits an RF
signal.
The standard display “
Frequency/Name ”
appears on the display panel. The red ON LED
¿
lights up and the transmission icon
ብ
is
displayed.
You can switch the bodypack transmitter on and
deactivate the RF signal on switch-on. For more
information, see page 13.
ብ
Ƹ
¸
¸
µ
¿