Sanyo PDP-32H1EN - Manual (Page 36)

36
SETTING
Color temperature
This function is used for selecting color temperature. Select
"Normal", "Cool" or "Warm" with
buttons which you wish to
select.
No operation shut off timer
This function turns off Plasma Monitor's power automatically, when
there is no operation of Remote Control or Front Control for 3 hours.
When "On" mode selected, if there is no operation for 3 hours, the
message "No operation : Power off" will be displayed for about 1
minute, and Plasma Monitor's power will be turned off automatically.
Video Format
Refer to "SELECTING VIDEO SYSTEM". (P33)
Reset
All adjustments in the memory can be reset to factory-settings.
1) Press
button . Reset menu will appear.
2) Press button to select "On" and then press OK button. All
adjustments in the memory is reset to factory-settings.
Return to factory settings Return to factory settings
: Select OK : OK : Select OK : OK
MENU : Return STATUS : Exit MENU : Return STATUS : Exit
Reset Reset
Off Off On On
CLEANING THE PLASMA MONITOR
Be sure to disconnect the AC Power cord from AC outlet before cleaning the Plasma Monitor.
Clean your Plasma Monitor as follows ;
●
Gently wipe the screen and cabinet with dry soft cloth.
●
The screen is likely to be damaged if it is not maintained properly. Do not use hard objects
like a hard cloth or paper. Do not use solvents or abrasives.
CAUTION :
Do not use benzene, thinner, or any volatile substances to clean the Plasma Monitor. These
chemicals may damage the cabinet finish.