beautypg.com

Location and function of controls, Battery installation, Using the adjusters – Sony VPH-V20M User Manual

Page 12: Push and slide to open the lid, Replace the lid

background image

12

Overview

Battery installation

1

Push and slide to open the lid.

2

Install three R6 (AA) batteries with the correct
polarity.

3

Replace the lid.

Notes

• If the projector does not operate properly, the

batteries might be worn out. Replace all three of
them with new batteries.

• The life of the batteries depends on frequency of

usage and how often you use the LIGHT button. If
they wear out quickly, replace them with new
alkaline batteries.

• To avoid damage from possible battery leakage,

remove the batteries when the remote commander
will not be used for a long time.

Notes on wired commander operation

Even if the remote commander is connected to the
CONTROL S IN jack of the projector via the remote
control cable (not supplied), the power is not supplied
to the remote commander from the projector. Install
the batteries in the battery compartment when you use
the remote commander as a wired remote commander.

Location and Function of Controls

Operable range of wireless remote control
operation

MUTING

INPUT SELECT

PIC

VIDEO

S VIDEO

INPUT A

TEST

R CENT

B CENT

PAGE

M SEL

ASPECT

RESET

Notes

• Be sure that there are no obstructions between the

remote commander and the projector.

• Operable range is limited. The shorter the distance

between the remote commander and the projector, the
wider the angle within which the remote commander
can control the projector.

Using the Adjusters

You can adjust the horizontal tilt and the angle of the
projector by turning the adjusters.
The adjusters are set to the shortest length at the
factory.

To adjust the horizontal tilt

Turn either adjuster to obtain horizontal balance.

To adjust the angle

Turn both adjusters to adjust the angle.

Approx. 7 m (23 feet) (max.)

30

°

30

°

30

°

30

°

This manual is related to the following products: