Sears KENMORE 625.34845 - Manual (Page 15)

CARE OF YOUR SOFTENER
SECTION 3
15
3B. KEEPING THE WATER SOFTENER CLEAN
COVERS
To keep your new Sears water softener looking
nice, apply a coat of paste wax and repeat once a
year. When dusty, wipe it with a damp cloth to
keep it sparkling.
NOTE:
Never use cleaners having ammonia or abrasives.
They may scratch and dull the surface.
NOZZLE AND VENTURI
A clean nozzle and venturi (FIG. 10) is a must for
the softener to work right. This small unit moves
brine from the salt storage tank to the resin tank
during regeneration. If it becomes plugged with
sand, silt, dirt, etc., the softener will not work and
you will get hard water.
To get to the nozzle and venturi, remove the
softener top cover. Be sure the softener is in
service cycle (no water pressure at nozzle and
venturi). Then, holding the housing tightly with 1
hand, turn the cap off. DO NOT LOSE THE LARGE
OĆRING SEAL. Lift out the screen support and
screen, then the nozzle and venturi. Wash and
rinse the parts in warm water until clean. If
needed, use a small brush to remove iron or dirt.
Also check and clean the gasket.
Carefully replace all parts in the correct order.
Lubricate the oĆring seal with silicone grease or
Vaseline and place in position. Install and tighten
the cap, by hand only. Do not overĆtighten and
break the cap or housing.
FIG. 10 CLEANING THE NOZZLE & VEN-
TURI
*INSTALL WITH
NUMBERED SIDE UP
CONCAVE SIDE DOWN.
IRON FROM THE RESIN BED
Your water softener takes hardness minerals
(calcium and magnesium) out of the water. Also, it
can control some clear water" iron. See maximum
allowed in the specifications on page 18. With
clear water iron, water from a faucet is clear when
first put into a glass. After 15 to 30 minutes, the
water begins to cloud or turn rust colored. A water
softener WILL NOT remove any iron which makes
the water cloudy or rusty as it comes from the
faucet (called red water iron). To take red water
iron out of water, or over the maximum of clear
water iron, an iron filter or other equipment is
needed. Your local Sears store has trained people
to help you with iron water problems.
If your water supply has clear water iron, even
though less than the maximum allowed, regular
resin bed cleaning is needed. Sears has resin bed
cleaner, Stock No. 42Ć34426 for this. Clean the bed
at least every 6 months. If iron shows up in the soft
water before 6 months, clean more often. Printed
instructions are on the resin bed cleaner bottle.
IF YOU HAVE QUESTIONS ABOUT CLEANING AND MAINTAINING YOURSOFTENER, CALL TOLL
FREE, NUMBER 1-800-426-9345.