Sherwood R-325 - Manual (Page 7)

REMOTE FUNCTION OVERVIEW
AMPLIFIER
1 1.POWER – for power control of this receiver or system.
(as described in amplifier chapter titled "POWER
ON/STANDBY")
1 2.SLEEP – for setting a time period after which the system
will automatically be switched to standby.
1 4.SYSTEM DISPLAY – for dimming displays of Sherwood
components connected by DIGI LINK II or III.
12.INPUT SELECTORS
35.MUTE – for decreasing the volume.
SURROUND PROCESSOR
28.SURROUND MODE
DOLBY PRO LOGIC, DOLBY 3 STEREO, THEATER,
HALL, SIMULATED, OFF – For selecting the different
surround modes.
29.CENTER MODE – for selecting the desired center mode
when in Dolby Pro Logic or Dolby 3 Stereo mode.
30.TEST TONE – for checking the output level of the front,
center and rear speakers.
31.DELAY TIME – for adjusting the delay time of the rear
channel.
32.REAR LEVEL / – for adjusting the rear level
(in Dolby Pro Logic, Theater, Hall, Simulated mode)
33.CENTER LEVEL / – for adjusting the center level
(only in normal mode or wide mode).
34.MASTER VOLUME / – for adjusting the volume.
TUNER
1 3.PRESET SCAN – for scanning the stations memorized in
memory.
1 5.0-9 DIGITS – for selecting stations in frequency direct
mode and for preset tuning in tuner mode.
CASSETTE DECK
15. – for stopping recording/play.
16. – for interrupting recording/play.
17.DECK SELECTOR A, B – for selecting deck A or B.
18. – for recording.
19. – for starting forward side play.
20. – for starting reverse side play.
21. – for winding the tape forward.
22. – for winding the tape reverse.
In the DIGI LINK III remote control system, lf pressing PLAY
on CD or TAPE monitor is selected antomatically without
selecting the input and PLAY, etc. starts.
COMPACT DISC PLAYER
1 5.0-9 DIGITS – for track selection, press desired button
among 10 buttons on the remote control and for disk
selection, select disc No.(1~5) within 2 sec. after
pressing the DISC button.
1 6.DISC (CD changer only) – for disc selection.
1 7. – to begin play.
1 8. – to stop play/clearing a program.
1 9. – for pausing play.
10. – for skipping backward and forward.
11. – for searching backward and forward.
13.INTRO – to preview each track only for 10 seconds.
14.REPEAT A <> B – to play a specific passage repeatedly.
EQUALIZER
23.PRESET – for selecting equalizer pattern.
24.USER – for adjusting equalizer pattern as desired.
25.FILE – for selecting desired equalizer pattern in the
preset or user mode.
26.TAPE M – for monitoring the sound of recording or
playback of cassette desk.
27.DISPLAY – for selecting equalizer display.
7
ENGLISH