Sony FR 20 User Manual

Page 4

2. Press and hold down the

on the headset until you see a solid blue

light.

3. Press and hold down the Multifunction button on the base until the

paring indicator has a solid blue light.

Note: Ensure that the headset and base are within 1m/3ft of each
other. Successful pairing will be indicated by 10 rapid flashes of both the
headset indicator and the pairing indicator on the base unit. Two single
tones will also be heard in the headset.

Verify pairing
To verify pairing, create an audio link between the headset and base by completing the following:
1. Press shortly the on either the headset

or the base’s Multifunction button.

2. An audible tone will be heard, and the Headset Indicator and Online Indicator will flash frequently.
3. To end the audio link, press shortly the on either the headset

or the base’s Multifunction button.

Note: You may verify pairing at any point except during telephone conversations.

2.3 Headset <––> handset switching (while on a call)
To switch from using the headset to the handset during a call:
1. Terminate the link between the headset and the base by pressing the

shortly on the headset

or the base’s Multifunction button

2. The call is now automatically transferred from the headset to the

handset, and can be continued in the handset.

3. To end the call, lower the telephone’s handset.
On telephones equipped with a line button, press the line button if you
have set up your GN 6210 for this.

To switch from using the handset to the headset during a call:
1. Press shortly either the headset

or the base’s Multifunction button

. The connection between

the headset and the base will be established shortly.

2. The call is now automatically transferred from the handset to the headset, and can be continued in the

headset.

3. To end the call, press shortly on either the headset

or the base’s Multifunction button.

4. To end the call, lower the telephone’s handset. On telephones equipped with a line button, press the

line button to end the call (if you have set up your GN 6210 for this).

2.4 Operating GN 6210 with GN 1000 RHL (accessory)
Please refer to the GN 1000 RHL user guide for directions on how to set up GN 1000. If you have lost the
user guide, please visit www.gnnetcom.com, where all user guides are available.

Make sure that the headset is turned on.

Making calls:
1. Press shortly on either the headset

or the base’s Multifunction button

. A connection will be

established shortly.

2. The GN 1000 RHL will be activated and your telephone’s handset will be lifted.
3. Dial the desired number when the dial tone is heard. The Headset Indicator and the base’s On-line

Indicator will flash rapidly for the duration of the call.

GN6210_UG_4.10 04/10/04 14:55 Side 4