Sanyo SCP-6600 - Manual (Page 14)

8
Using the Battery
Installing the Battery
To install the LiIon battery:
1. Insert the battery into the opening on the back of the phone at a
45-degree angle, making sure to line up the gold contacts.
Gently press down until the battery snaps into place.
2. Install the protective cover by lining up the tabs at a 45-degree
angle, and gently press down until the cover snaps into place.
Removing the Battery
Warning! Do not handle a damaged or leaking Lilon battery as you can be
burned.
To remove your battery:
1. Make sure the power is off so that you don’t lose any stored
numbers or messages. Remove the protective cover by pressing
the release latch and pulling up on the back of the cover.
2. With the tab on the top left of the battery, use your thumbnail to
lift and then remove the battery as indicated in the diagram.
1. The Basics