Sanyo R410A - Manual (Page 54)

54
K
3-36. When Using Wireless Remote Controller Instead Of Wired Remote Controller
When the wireless remote controller is to be used, slide the switch on the indoor unit control PCB.
• If this setting is not made, an alarm will occur. (The operation lamp on the display blinks.)
• This setting is not necessary if both the wired remote controller and wireless remote controller are used.
• The location of the switch varies depending on the type of PCB used. Check the model name before making the
setting.
KHX0752 / 0952 / 1252 / 1852
KHX2452
Setting at time of
factory shipment
Setting at time of
factory shipment
Slide No. 3 on SW101
from ON OFF.
Slide No. 3 on SW101
from ON OFF.
CR-KR74GXH56A-0
CR-KR254GXH56A-0
07-007 W-2WAY_II_NA 1/23/07 6:09 PM Page 54