SECO-LARM USA ENFORCER Wireless RF Request-to-Exit Buttons SD-8103GT-PEQ - Manual (Page 4)

ENFORCER Wireless Request-to-Exit Plates
4 SECO-LARM U.S.A., Inc.
WARRANTY This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only,
at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2008 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of SECO-LARM.
SECO-LARM
® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326 E-mail: sales @ seco-larm.com
mi-SD-8XXX.docx
Troubleshooting:
PITSW1
.docx
LED is red 9V battery is low, replace with new one
LED does not light Check battery connection
Replace 9V battery
LED lights blue, but does not
activate lock
Check to make sure wireless request-to-exit plate is not
housed in a metal box
Test wireless request-to-exit plate closer to the receiver
Clear codes from receiver, and re-learn wireless plate
transmitter code
Also Available from SECO-LARM:
Desktop RF
Transmitters
Wireless RF
Receivers
SK-910R4 SK-919TP4D-P
Handheld
Transmitters
SK-919TP4H-NU
Slim-Line
Push-to-Exit Plates
Pendant-Style
Transmitters
Extended Range
Antenna
SK-91ERSD SK-919TP4J-N SD-7104SGEX1Q
Single-Gang
Push-to-Exit Plates
SD-7201GC-PE1
SK-919TDWS-BU
Wired 1-channel
Transmitter
(shown) (shown) (shown)
(shown) (shown) (shown)