Sterling Plumbing Bath 7113 Series - Manual (Page 19)

7. Complete the Installation
CAUTION: Risk of property damage. Make sure that a watertight seal exists
around the drain and overflow.
NOTE: If you have not already done so, remove the apron panel following the
instructions below.
Removing the Apron Panel
Insert a flat-blade screwdriver or other prying tool into one of the two screwdriver
slots.
Use the screwdriver to pry the bottom clip out and release the clip.
When all bottom clips are released, pull the bottom of the panel away from the
apron to release the remaining clips.
When the bottom of the panel is clear, lower the panel until the top of the panel is
clear.
Complete the Installation
Connect the drain to the trap according to the drain manufacturer’s instructions.
Install the faucet trim, bath spout, shower door, and any accessories according to
each manufacturer’s instructions.
Remove the protective covering from the bath.
Open the water supply lines, then run the water to flush out any debris.
Close the valves.
Check all connections for leaks.
Clips/Clips/Clips
Apron Panel
Panneau du bandeau
Panel del faldón
Apron Frame
Cadre du bandeau
Estructura del faldón
Tabs
Languettes
Lengüetas
Sterling 19 1072812-2-A