Sunbeam SM8650 - Manual (Page 11)

9
Using the chopper attachment (Models SM6400
and SM8650)
1. Place the chopper bowl on the non-slip
mat, ensuring the surface is clean and
level.
2. Fit the stainless steel chopping blade into
the chopper bowl.
3. Place food into the chopper bowl.
4. Attach the lid onto the chopper bowl and
rotate the lid in a clockwise direction until
it locks into position.
5. Insert the motor housing into the hole on
the top of the chopper attachment until
you hear a click. See Figure 3.
6. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
7. Hold the bowl with one hand while
operating the power button with the other.
Setting (I) is low speed and setting (II)
is high speed (for models SM6200 and
SM6400).
Or, with your StickMaster Pro (SM8650),
you can select the optimal speed for
the processing task, by turning the
speed control dial from 1 to 5 and then
depressing the power button (I). Speed one
on the speed control dial is the slowest and
speed five is the fastest.
Note: All stick mixers are designed to
operate only whilst the power buttons remain
depressed.
8. For an extra boost of power during
operation, the turbo speed button (II) may
be depressed (for model SM8650).
Note: The power button (I) should be released
when selecting the turbo speed button (II).
9. To stop the StickMaster, take your finger
off the power button or turbo speed button
(for model SM8650).
10. To detach the chopper attachment, push
the buttons at either side of the base of
the motor housing until the two pieces
separate. See Figure 4.
Using your StickMaster continued
Figure 3
Figure 4