SoundCraft Five Monitor Series User Manual

Page 29

FIVE Monitor Functional Description

4.3

HHFF

The HF section is fully sweepable from 1kHz to 20kHz. Q is variable from 0.5 to

3.0, or the band may be switched to a shelving response by turning the Q control

fully anticlockwise.

HHMMFF

The HMF spans the range 500Hz to 8kHz. Q is variable from 0.5 to 3.0.

LLMMFF

The LMF spans the range 70Hz to 1.5kHz. Q is variable from 0.5 to 3.0.

LLFF

The HF section is fully sweepable from 30Hz to 480Hz. Q is variable from 0.5 to

3.0, or the band may be switched to a shelving response by turning the Q control

fully anticlockwise.

EEQQ

The EQ section is active when the EQ switch is pressed, and bypassed when the

switch is released, allowing easy A/B comparison of the signal with or without EQ.

LL//RR MMoonniittoorr SSeennddss

A dual-concentric control routes the signal to the L/R output (on the lower section

of the Master Module). The control may either be configured as two mono sends

(Left and Right), or, if the Global Mode STE switch on the output section on the

Master module is pressed, the send becomes a stereo pair, with the top knob

being send level, and the lower knob being a PAN control. The sends are muted

unless the ON switch is pressed, and may be switched pre-fader by pressing the

PRE switch. The pre-fade source may be configured as pre-fade/post-mute, pre-

mute or pre-EQ/pre-insert using internal jumpers. (see chapter 2).

MMoonnoo//SStteerreeoo MMoonniittoorr SSeennddss

The sends to outputs 9-16 (24-bus consoles) or 1-16 (32-bus consoles) are on dual

concentric pots, and each row can be configured at the touch of a button as either

a stereo send with level on the top knob and pan on the lower, or a pair of mono

sends. These pairs of mixes are controlled by the faders in the output modules,

and are labelled 1A & B (8A & B on 24-bus consoles)to 16A and B. Stereo mode is

selected by pressing the Global Mode STE button on the respective output mod-

ule. The sends are muted unless the ON switch is pressed, and may be switched

pre-fader by pressing the PRE switch. The pre-fade source for sends 9-16 may be

configured as pre-fade/post-mute, pre-mute or pre-EQ/pre-insert using internal

jumpers. (see chapter 2).

MMoonnoo MMoonniittoorr SSeennddss

(24-bus consoles only)

The lower 8 sends on 24-bus consoles are configured as full-time mono sends,

using single pots. The output modules for these mixes are similar to the output

modules for stereo pairs of outputs, except the Global Mode STE switch is omit-

ted, and the modules comprise two separate output sections. The sends are

muted unless the ON switch is pressed, and may be switched pre-fader by press-

ing the PRE switch. The pre-fade source for sends 1-8 may be configured as pre-

fade/post-mute, pre-mute or pre-EQ/pre-insert using internal jumpers. (see chap-

ter 2).

FFaaddeerr

A high-quality 100mm channel fader controls the level to all busses, and has 10dB

of gain when full up as well as an expanded scale around the critical unity gain area,

for maximum resolution.

32-bus console