Sanyo PLC-WU3800 - Manual (Page 69)

69
Appendix
– Check PC adjustment or Screen and adjust them.
See pages 32-33, 36-37 .
–PIN code lock is being set. Enter a PIN code (" 134" or numbers
you have set). See pages 20, 57-58.
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 56.
– Unlock the Key lock function for the remote control function. See
page 56.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 73.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at Key lock
under Security of Setting section. See page 57.
– Contact the dealer where you purchased the projector or the service
center.
The image is distorted or runs off .
PIN code dialog box appears at
start-up .
The Remote Control does not work .
Indicator blinks or lights .
The exclamation mark appears on
the screen .
Top control does not work .
Unable to unlock the Logo PIN code
lock, Security key lock or Security
PIN code lock .