Woodstock SHOP FOX M1001 - Manual (Page 19)

-17-
M1001 6" x 26" Vertical Mill
SE
T
U
P
NOTICE
Follow spindle break in procedures
on Page on page 24 after the test run
and before performing any operations
with this machine! Failure to follow the
break-in procedures included in this
manual may lead to shortened tool life
and may void warranty.
Figure 13. Spindle controls.
To begin the test run procedure, do these steps:
1. Make sure there are no obstructions around or
underneath the spindle.
2. Set the mill to the slowest RPM. See Page on page
23 for adjusting RPM.
3. Put on safety glasses, and make sure any bystanders
are wearing safety glasses and are out of the way.
4. Plug the machine into the power outlet and push the
ON/OFF switch to turn the mill ON, but make sure
that your hand stays over the switch. The mill should
run smoothly, with little or no vibration or rubbing
noises.
• If you hear squealing or grinding noises, turn the
machine OFF immediately. Wait for the mill to
stop moving, unplug the machine, and correct any
problems before further operation.
• If the source of an unusual noise or vibration is not
readily apparent, contact our technical support
for help at (360) 734-3482 or contact us online at
[email protected].
Test Run
Complete this process once you have familiarized yourself
with all instructions in this manual and you have made
sure the machine is completely lubricated as described in
Lubrication onon page 27Pon page 27. The purpose of
the test run is to make sure the motor is working properly
before proceeding.
Figure 13 shows the location of the ON/OFF buttons and
the SPINDLE DIRECTION toggle for the Model M1001.
• The ON/OFF buttons control power to the spindle.
• The SPINDLE DIRECTION toggle will change the
direction the spindle rotates. DO NOT change spindle
rotation until spindle has come to a complete stop!
Spindle Controls
Spindle Direction
ON/OFF