Woodstock SHOP FOX M1001 - Manual (Page 18)

-16-
M1001 6" x 26" Vertical Mill
SE
T
U
P
Figure 10. Headstock lock nuts.
Figure 11. Handwheel locations.
Figure 12. Drawbar location.
The longitudinal and cross handwheels shown in Figure
11 need to be installed. The handwheel handles will
need to be installed on all the handwheels. Attach
the handwheels and handles with the hex wrench,
screwdriver, and hardware provided .
Handle Installation
Drawbar
Open the top cover and insert the drawbar into the
splined spindle located in the center of the front cone
pulley (see Figure 12).
Assembly
The Model M1001 comes fully assembled from the factory
with the exception of one of the longitudinal handwheels
and the cross handwheel. The head has been rotated to
reduce the overall dimension of the shipping crate.
Headstock Adjustment
Loosen the three nuts at the column and rotate the
headstock to the "0" position on the column scale (see
Figure 10).
Nuts 2 & 3
Hidden from
View
Longitudinal
Handwheel
Cross
Handwheel
Drawbar
Single Shot Lubrication
Unscrew the filler cap and fill the reservoir with non-
detergent SAE-20 or similar way oil. Manually pump the
lever until resistance from the oil pressure is felt (see
Figure 9).
Knee Feed
Figure 9. Single shot lubrication system.