Woodstock SHOP FOX M1001 - Manual (Page 12)

-10-
M1001 6" x 26" Vertical Mill
EL
EC
TR
IC
A
L
Availability
Before installing the machine, consider the availability
and proximity of the required power supply circuit. If an
existing circuit does not meet the requirements for this
machine, a new circuit must be installed. To minimize
the risk of electrocution, fire, or equipment damage,
installation work and electrical wiring must be done by
a qualified electrician in accordance with all applicable
codes and standards.
Full-Load Current Rating
The full-load current rating is the amperage a machine
draws at 100% of the rated output power. On machines
with multiple motors, this is the amperage drawn by the
largest motor or sum of all motors and electrical devices
that might operate at one time during normal operations.
Full-Load Current Rating at 110V ................ 16 Amps
Full-Load Current Rating at 220V ..................8 Amps
The full-load current is not the maximum amount of amps
that the machine will draw. If the machine is overloaded,
it will draw additional amps beyond the full-load rating.
If the machine is overloaded for a sufficient length of
time, damage, overheating, or fire may result—especially
if connected to an undersized circuit. To reduce the
risk of these hazards, avoid overlovading the machine
during operation and make sure it is connected to a
power supply circuit that meets the requirements in the
following section.
Electrocution, fire, or equipment
damage may occur if machine is not
correctly grounded and connected to
the power supply.
For your own safety and protection of
property, consult a qualified electrician
if you are unsure about wiring practices
or electrical codes in your area.
ELECTRICAL