Sierra Housewares S5012 - Manual (Page 59)

55
Areas
7
From the Area Status Menu,
you can arm individual areas of
your system. Each partition can
be armed with full arming, home
arming or instant home-arming.
If an area is not ready to be
armed, your command to arm
this area causes one of two
things to happen. If your sys-
tem is programmed for Force
Arming (see Section 8), the
area is armed, but any trouble/
faulted zones are automatically
bypassed. If your system is not
programmed for Force Arming,
the Zone Status Menu appears.
In that case, you must correct
or bypass any trouble or faulted
zones before arming can take
place.
To Arm One Area:
1. Enter your user code. You see
something like this:
AREA 12345678
STATUS RNAHIRAH
2. To arm an area using full arm-
ing, press that area number.
3. To arm an area using home
arming, press the key
followed by the area number.
4. To arm an area using instant
home-arming, press and hold
the [instant] key for
2 seconds until you hear two
beeps. Then, enter the area
number.
Arming Individual Areas
Using Multiple Keypads in an Area
In any area, only one keypad can be used at a time. If you try to
use another keypad while one is in use, you see the following:
ANOTHER KEYPAD
IS IN USE