Sony SIR4260V - Manual (Page 12)

COLOR DOME CAMERA User Guide 22 COLOR DOME CAMERA User Guide 23
• Because there can be a difference in the effectiveness of HLC according to the amount of
light area in the screen, optimize the installation angle for the best HLC performance.
• When dark, the HLC is only activated when a bright light exceeding a specific size in NIGHT
ONLY mode.
• The HLC is not activated in day light or when bright light is not present at night in NIGHT
ONLY mode.
• BLC Function doesn't work in the B/W mode of the DAY/NIGHT menu.
Notes
3. Select a desired mode using the Function Setup switch and press the Function Setup switch.
172
5
120
LOW
Select ‘BLC’ to adjust the area to be
enhanced then adjust the level.
HLC : Enable the user to change the level,
limit, mask color/tone and area.
HLC (High Light Compensation) :
If the scene contains extremely bright light areas such as; from car headlights, the light
can mask out much of the on-screen detail.
- LEVEL : Adjust level of the HLC function.
- LIMIT : Enable to change the operating condition.
- MASK COLOR/TONE : Change the color / transparency of the masking area.
(Black, Red, Blue, Cyan, Magenta)
- TOP/BOTTOM/LEFT/RIGHT : Adjust the area to be enhanced
OFF : Not being used
2. Select a desired mode using the Function Setup.
BLC : Enables a user to directly select a desired area from a picture, and to view the
area more clearly.
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.SSDR OFF
5.BACKLIGHT OFF
6.SSNR3 ON
Operating Your Camera
2. Select a desired mode using the Function Setup switch.
OFF : Deactivates SSNR3. Noise is not reduced.
ON : Activates SSNR3 so that noise is reduced.
3. Set the SSNR3 mode to ‘ON’ and press the Function Setup switch. Then you can adjust the
noise reduction level.
This function reduces the background noise in a low luminance environment.
1. When the SETUP menu screen is displayed, select ‘SSNR3’ by using the Function Setup
switch so that the arrow indicates ‘SSNR3’.
SSNR3
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.SSDR OFF
5.BACKLIGHT OFF
6.SSNR3 ON
7.DAY/NIGHT AUTO
• You cannot set the SSNR3 to ‘ON’ or ‘OFF’ when the AGC mode of the EXPOSURE menu is
‘OFF’.
• When adjusting the noise reduction level in the SSNR mode, remember that the higher the
level set, the more the noise level will be reduced, as will the brightness of the image.
Notes