Getting ready to install the refrigerator, Leveling the refrigerator, Case 1 – Samsung DA99-01906A User Manual
Page 11: Case 2, Case 1) the appliance tilts down to the left, Case 2) the appliance tilts down to the right
Leg
screw Driver
Leg
screw Driver
100mm
100mm
gEtting rEaDy to instaLL tHE rEfrigErator
LEVELLing tHE rEfrigErator
If the front of the appliance is slightly higher than the rear, the door can be opened and
closed more easily.
case 1) The appliance tilts down to the left.
• Turn the left adjusting leg in the direction of the arrow until the appliance is
level.
case 2) The appliance tilts down to the right.
• Turn the right adjusting leg in the direction of the arrow until the appliance is
level.
at least
50mm
1,440mm
1,495mm
at least
50mm
at least
50mm
1,380mm
1,425mm
at least
50mm
When installing, servicing, or cleaning behind the refrigerator, be sure to pull the
unit straight out and push back in straight after finishing.
Also, make sure your floor supports the full-load refrigerator.
Otherwise, it may cause floor damage.
CAUTION
• Please tie up the extra length of the power cord at the
back of the refrigerator so as not to be touched on the
floor preventing the power cord from being crushed by
the rollers upon relocation.
CAUTION
setting up
_11
01
s
E
tting
u
P
• Allow clearance to the right, left, back and top when installing. This will help reduce
power consumption and keep your energy bills lower.
• Do not install the refrigerator where the temperature will go below 10°C.