Shindaiwa X7502825300 - Manual (Page 12)

12
NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
Use only authorized Shindaiwa parts and
accessories with your Shindaiwa trimmer.
Do not make modifications to this unit
without written approval from Shindaiwa,
Inc.
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
NEVER use a cracked or warped cut-
ting attachment: replace it with a ser-
viceable one.
Checking Unit Condition
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could
damage the engine.
NEVER operate a unit with worn or
damaged fasteners or attachment
holders.
WARNING!
A cutting attachment shield
or other protective device is no guar-
antee of protection against rico-
chet. YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
OFF
Idle the engine briefly before stop- 1.
ping (about 2 minutes).
Slide the ignition switch to the “O”
2.
(Engine OFF) position.
Stopping the Engine
Starting the Engine (continued)
Starting A Flooded Engine
IMPORTANT!
When the unit is turned off make sure
the cutting attachment has stopped
before the unit is set down.
Shoulder strap
required for use
with Brushcutters
Operation
IMPORTANT!
Adjust the shoulder strap so the shoul-
der pad rests comfortably on the off-
side shoulder and the cutting path of
the cutting attachment is parallel to
the ground. Make sure all hooks and
adjustment devices are secure.
WARNING!
Always wear a shoulder
strap or harness when operating
this unit. Using a harness with a
brushcutter allows you to main-
tain proper control of the unit and
reduces fatigue during extended
operation.
Shoulder strap
Hook the strap hook to the hanger 1.
on the outer tube.
Wear the shoulder strap so that the
2.
hook stays at your right hand side.
Adjust the length of the shoulder
3.
strap so that you can hold and oper-
ate the machine comfortably.
NOTE:
Using a shoulder strap when operat-
ing this unit with a blade allows you
to maintain proper control of the unit
and reduces fatigue during extended
operation.
Slide the ignition switch to the “I” (ON) position 1. .
Open the choke, put the throttle lever in the full throttle position, then clear excess fuel from the combustion chamber by 2.
cranking the engine several times.
If the engine still fails to start or fire, refer to the troubleshooting flow chart at the end of this manual.
3.